User Manual

Stabilization Strength
This control varies the amount of smoothing or stabilization applied, from 0.0 (no change) to 1.0
(maximum).
Smoothing
The Spherical Stabilizer node can eliminate all rotation from a shot, fixing the forward viewpoint
(Still mode, 0.0) or gently smooth out any panning, rolling, or tilting to increase viewer comfort
(Smooth mode, 1.0). This slider allows either option or anything in between.
Offset Rotation
Often a shot is not entirely level and needs the horizon to be realigned, or perhaps a desired
pan should be reintroduced after fully stabilizing the shot. The Offset Rotation controls allow
additional manual control of the Spherical Stabilizer’s rotation of the footage, for pitch/tilt (X),
pan/yaw (Y), and roll (Z), respectively. Rotation is always performed in the order X, Y, Z.
Common Controls
Settings Tab
The Settings tab in the Inspector is duplicated in other VR nodes. These common controls are
described in detail in the following “The Common Controls” section.
The Common Controls
Nodes that handle VR operations share a number of identical controls in the Inspector. This
section describes controls that are common among VR nodes.
Inspector
Chapter – 109 VR Nodes 2473