User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab is used to determine the format of the input image and the desired
output format.
From/To
Auto: Auto detects the incoming image layout from the metadata and image frame
aspect.
VCross and HCross: VCross and HCross are the six square faces of a cube laid out in a
cross, vertically or horizontally, with the forward view in the center of the cross in a 3:4
or 4:3 image.
VStrip and HStrip: VStrip and HStrip are the six square faces of a cube laid vertically or
horizontally in a line, ordered as Left, Right, Up, Down, Back, Front (+X, -X, +Y, -Y, +Z, -Z)
in a 1:6 or 6:1 image.
LatLong: LatLong is a single 2:1 image in equirectangular mapping.
Rotation Order
These buttons choose the ordering of the rotations around each axis. For example, XYZ rotates
first around the X axis (pitch/tilt), then around the Y axis (pan/yaw), and then around the Z axis
(roll). Any of the six possible orderings can be chosen.
Rotation
These dials rotate the spherical image around each of the X, Y, and Z axes, offering
independent control over pitch/tilt, pan/yaw, and roll, respectively.
Common Controls
Settings Tab
The Settings tab in the Inspector is duplicated in other VR nodes. These common controls are
described in detail at the end of this chapter in “The Common Controls” section.
Chapter – 109 VR Nodes 2470