User Manual

Table Of Contents
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other Transform nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
Resize [RSZ]
The Resize node
Resize Node Introduction
Use the Resize node to increase or decrease the resolution of an input image. This is useful for
converting images from one format to another (for example, from film to video resolution). This
node actually changes the resolution of the image.
NOTE: Because this node changes the physical resolution of the image, animating the
controls is not advised.
Inputs
The single input on the Resize node is used to connect a 2D image for resizing.
Input: The orange input is used for the primary 2D image you want to resize.
Basic Node Setup
Below, the Resize node is inserted between the MediaIn1 node and the background input of the
Merge. Unlike using a Transform tool, resizing the MediaIn1 changes the resolution of the clip.
The resized MediaIn1 node connected to the orange background input also sets the resolution
of the Merge output.
The Resize node can be used to scale an image and change its resolution
Chapter – 108 Transform Nodes 2451