User Manual

Table Of Contents
Inputs
The single input on the Crop node is used to connect a 2D image for cropping.
Input: The orange input is used for the primary 2D image you want to crop.
Basic Node Setup
Below, the Crop node is inserted between the MediaIn1 node and the background input of the
Merge. Unlike using a mask tool, cropping the MediaIn1 changes the resolution of the clip. The
cropped MediaIn1 node connected to the orange background input also sets the resolution of
the Merge output.
The Crop node can be used to cut out a portion of an image
Inspector
Controls Tab
The Controls tab provides XY Offset and XY Size methods for cropping the image.
Offset X and Y
These controls position the image off the screen by pushing it left/right or up/down. The
cropped image disappears off the edges of the output image. The values of these controls are
measured in pixels.
Size X and Y
Use these controls to set the vertical and horizontal resolution of the image output by the Crop
node. The values of these controls are measured in pixels.
Chapter – 108 Transform Nodes 2443