User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab includes parameters for adjusting the offsets, strength, speed, and frequency
of the simulated camera shake movement.
Deviation X and Y
These controls determine the amount of shake applied to the image along the horizontal (X)
and vertical (Y) axes. Values between 0.0 and 1.0 are permitted. A value of 1.0 generates shake
positions anywhere within the boundaries of the image.
Rotation Deviation
This determines the amount of shake that is applied to the rotational axis. Values between 0.0
and 1.0 are permitted.
Randomness
Higher values in this control cause the movement of the shake to be more irregular or random.
Smaller values cause the movement to be more predictable.
Overall Strength
This adjusts the general amplitude of all the parameters and blends that affect in and out. A
value of 1.0 applies the effect as described by the remainder of the controls.
Speed
Speed controls the frequency, or rate, of the shake.
Frequency Method
This selects the overall shape of the shake. Available frequencies are Sine, Rectified Sine, and
Square Wave. A Square Wave generates a much more mechanical-looking motion than a Sine.
Chapter – 108 Transform Nodes 2440