User Manual

Table Of Contents
Display Options Tab
The Display Options tab lets you customize the look of onscreen controls in the viewer.
Show Pattern Names
This option defines whether the Tracker’s pattern names will be displayed in the viewer. Switch
it off to see the pattern rectangle instead.
Enlarged Pattern on Dragging
This option defines whether there is a magnified thumbnail view when positioning the pattern
rectangle.
Enlargement Scale
The zoom factor that is used when positioning the pattern rectangle when the above option is
activated.
TIP: The outputs of a tracker (seen in the Connect to… menu) can also be used by
scripts. They are:
SteadyPosition: Steady Position
UnsteadyPosition: Unsteady Position
SteadyAxis: Steady Axis
SteadySize: Steady Size
UnsteadySize: Unsteady Size
SteadyAngle: Steady Angle
UnsteadyAngle: Unsteady Angle
Position1: Tracker 1 Offset position
PerspectivePosition1: Tracker 1 Perspective Offset position
PositionX1: Tracker 1 Offset X position (3D Space)
PositionY1: Tracker 1 Offset Y position (3D Space)
PerspectivePositionX1: Tracker 1 Perspective Offset X position (3D Space)
PerspectivePositionY1: Tracker 1 Perspective Offset Y position (3D Space)
SteadyPosition1: Tracker 1 Steady Position
UnsteadyPosition1: Tracker 1 Unsteady Position (likewise for the 2nd, 3rd, and so on)
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other Tracking nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
Chapter – 107 Tracker Nodes 2404