User Manual

Inspector
Trackers Tab
The Trackers tab contains controls for creating, positioning, and initiating tracking operations.
After tracking, offset controls are used to improve the alignment of the image following
the track.
Track Buttons
There are four buttons to initiate tracking, and one button in the middle used to stop a track in
progress. These buttons can track the current pattern forward or backward in time. Holding the
pointer over each button displays a tooltip with the name of each button.
The buttons operate as follows:
 Track Reverse: Clicking this button causes all active trackers to begin tracking, starting
at the end of the render range and moving backward through time until the beginning
of the render range.
 Track Reverse From Current Time: Clicking this button causes all active trackers to
begin tracking, starting at the current frame and moving backward through time until
the beginning of the render range.
 Stop Tracking: Clicking this button or pressing ESC stops the tracking process
immediately. This button is active only when tracking is in process.
Chapter – 107 Tracker Nodes 2393