User Manual

Inspector
Controls Tab
The Controls tab is divided into identical parameters for the left eye and right eye. The
parameters are used to select which eye to recreate and the methods used for the
interpolation.
Enable
The Enable checkbox allows you to activate the left or right eye independently. The New Eye
will replace enabled eye with an interpolated eye. For example, if the left eye is your “master”
eye and you are recreating the right eye, you would disable the left eye and enable the
right eye.
Lock XY
Locks the X and Y interpolation parameters. When they are unlocked, you can provide separate
interpolation factors for using the X and Y disparity. For example, if you are working with the
right eye and you have the X Interpolation slider set to 1.0 and the Y Interpolation slider set to
-1.0, you will be effectively interpolating the left eye onto the right eye but vertically aligned to
the left eye.
XY Interpolation Factor
Interpolation determines where the interpolated frame is positioned, relative to the two source
frames: A slider position of -1.0 outputs the frame Left and a slider position of 1.0 outputs the
frame Right. A slider position of 0.0 outputs a result that is halfway between Left and Right.
Chapter – 106 Stereo Nodes 2373