User Manual

 Right Only: The right eye is rotated, while the left eye remains unaltered.
 Split Both
: Left and right eyes are rotated in opposite directions.
Angle
This dial adjusts the angle of the rotation. Keep in mind that the result depends on the Balance
settings. If only rotating one eye by, for example, 10 degrees, a full 10-degree rotation will be
applied to that eye.
When applying rotation in Split mode, one eye will receive a -5 degree and the other eye a
+5 degree rotation.
Translation Filter Method
This menu chooses the filter method that delivers the best results depending on the content of
your footage.
Visualization
This control allows for different color encodings of the left and right eye to conveniently
examine the results of the above controls without needing to add an extra Anaglyph or
Combiner node.
Set this to None for final output.
Stack Mode
Determines how the input images are stacked.
When set to Separate, the right input and output will appear, and separate left and right images
must be connected.
Swap Eyes
With Stacked Mode, image stereo pairs’ left and right images can be swapped.
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other Stereo nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
New Eye [NE]
The NewEye node
NOTE: The New Eye node is available only in Fusion Studio and
DaVinci Resolve Studio.
Chapter – 106 Stereo Nodes 2371