User Manual

Combiner [COM]
The Combiner node
NOTE: The Combiner node is available only in Fusion Studio and
DaVinci Resolve Studio.
Combiner Node Introduction
The Combiner node takes two stereoscopic inputs and creates so-called “stacked images” with
the left and right eye, either side by side or on top of each other. Stereoscopic nodes are
available only in Fusion Studio and DaVinci Resolve Studio.
Inputs
The two inputs on the Combiner node are used to connect the two images that get combined in
a stacked stereo image.
–
Image 1 Input: The orange input is used to connect the 2D image representing the
left eye in the stereo comp.
–
Image 2 Input: The green input is used to connect the 2D image representing the
right eye in the stereo comp.
Basic Node Setup
Below, a left eye image and right eye image are connected to the Combiner node to create a
single stacked stereo image. It can be more efficient to render out the stacked stereo images
as EXR files than to generate the disparity on-the-fly.
Left and right eye images are connected into a Combiner node to generate a stacked stereo image
Inspector
Chapter – 106 Stereo Nodes 2360