User Manual

Table Of Contents
Anaglyph [ANA]
The Anaglyph node
NOTE: The Anaglyph node is available only in Fusion Studio and
DaVinci Resolve Studio.
Anaglyph Node Introduction
The Anaglyph node is used to create stereoscopic images by combining separate left eye and
right eye images. It is most commonly used at the end of a stereoscopic workflow to display or
deliver the final result.
Inputs
The three inputs on the Anaglyph node are the left eye input, right eye input, and effect mask.
Left Eye Input: The orange input is used to connect the 2D image representing the
left eye in the stereo comp.
Right Eye Input: The green input is used to connect the 2D image representing the
right eye in the stereo comp.
Effect Mask: The blue input is for a mask shape created by polylines, basic primitive
shapes, paint strokes, or bitmaps from other tools. Connecting a mask to this input
limits the stereoscopic creation to only those pixels within the mask.
Basic Node Setup
The Anaglyph node is usually placed at the end of a stereoscopic node tree to display the
final result.
When using separate images for the left and right eye, the left eye image is connected to the
orange input, and the right eye image is connected to the green input of the node. When using
either horizontally or vertically stacked images containing both left eye and right eye
information, these only connect to the orange input.
An Anaglyph node using separate left and right eye inputs
Chapter – 106 Stereo Nodes 2356