User Manual

Table Of Contents
Basic Node Setup
The pVortex node is placed in between the pEmitter and pRender nodes.
A pVortex node creates a spiraling motion for particles that fall within its pull
Inspector
Randomize
The Random Seed slider and Randomize button are presented whenever a Fusion node relies
on a random result. Two nodes with the same seed values will produce the same random
results. Click the Randomize button to randomly select a new seed value, or adjust the slider to
manually select a new seed value.
Strength
This control determines the Strength of the Vortex Force applied to each particle.
Power
This control determines the degree to which the Strength of the Vortex Force falls off
with distance.
X, Y, and Z Offset
Use these sliders to set the amount by which the vortex Offsets the affected particles.
Size
This is used to set the Size of the Vortex Force.
Angle X and Y
These sliders control the amount of rotational force applied by the Vortex along the X
and Y axes.
Chapter – 103 Particle Nodes 2314