User Manual

Basic Node Setup
The pTangent Force node is inserted between a pEmitter and a pRender node.
The pTangent Force node positions a tangent force that particles maneuver around
Inspector
The controls for this node are used to position the offset in 3D space and to determine the
strength of the tangential force along each axis independently.
Randomize
The Random Seed slider and Randomize button are presented whenever a Fusion node relies
on a random result.
Two nodes with the same seed values will produce the same random results. Click the
Randomize button to randomly select a new seed value, or adjust the slider to manually select a
new seed value.
X, Y, Z Center Position
These controls are used to represent the X, Y, and Z coordinates of the Tangent force
in 3D space.
X, Y, Z Center Strength
These controls are used to determine the Strength of the Tangent force in 3D space.
Common Controls
Conditions, Style, Region, and Settings Tabs
The Conditions, Style, Region, and Settings tabs are common to all Particle nodes, so their
descriptions can be found in “The Common Controls” section at the end of this chapter.
Chapter – 103 Particle Nodes 2311