User Manual

Table Of Contents
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other miscellaneous nodes. These
common controls are described in detail in the following “The Common Controls” section.
The Common Controls
Nodes that handle miscellaneous operations share a number of identical controls in the
Inspector. This section describes controls that are common among miscellaneous nodes.
Inspector
Settings Tab
The Settings tab in the Inspector can be found on every tool in the miscellaneous nodes. The
controls are consistent and work the same way for each tool.
Blend
The Blend control is used to blend between the tool’s original image input and the tool’s final
modified output image. When the blend value is 0.0, the outgoing image is identical to the
incoming image. Normally, this will cause the tool to skip processing entirely, copying the input
straight to the output.
Chapter – 100 Miscellaneous Nodes 2237