User Manual

Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other miscellaneous nodes. These
common controls are described in detail at the end of this chapter in “The Common
Controls” section.
Wireless Link [Wire]
The Wireless Link node
Wireless Link Node Introduction
The Wireless Link node helps manage the tangle of connection lines in a node tree by
wirelessly connecting one 2D node to another 2D node.
Although Wireless Links can be helpful, try to keep as much of a node tree as visible as
possible; otherwise, you lose one of the main benefits of a node tree.
Inputs
There are no inputs on this node.
Basic Node Setup
There is no setup for this node. It is a free-standing node that connects “wirelessly” using the
control in the Inspector.
Inspector
Controls Tab
The Controls tab in the Wireless Link node contains a single Input field for the linked node.
Input
To use the Wireless Link node, in the Node Editor, drag the 2D node into the Input field of the
Wireless Link node. Any change you make to the original node is wirelessly replicated in the
Wireless Link node. You can use the output from the Wireless Link node to connect to a
nearby node.
Chapter – 100 Miscellaneous Nodes 2236