User Manual

Table Of Contents
Inspector
Controls Tab
Mode
The Mode menu has two choices depending on whether you want to adjust or offset the
existing domain or set precise values for it.
The same operations can be performed in Set or in Adjust mode. In Adjust mode, the sliders
default to 0, marking their respective full extent of the image. Positive values shrink the DoD
while negative values expand the DoD to include more data.
Set mode defaults to the full extent of the visible image. Sliders default to a scale of 0-1 from left
to right and bottom to top.
Left
Defines the left border of the DoD. Higher values on this slider move the left border toward the
right, excluding more data from the left margin.
1 represents the right border of the image; 0 represents the left border. The slider defaults to 0
(left border).
Bottom
Defines the bottom border of the DoD. Higher values on this slider move the bottom border
toward the top, excluding more data from the bottom margin.
1 represents the top border of the image; 0 represents the bottom border. The slider defaults to
0 (bottom border).
Right
Defines the right border of the DoD. Higher values on this slider move the right border toward
the left, excluding more data from the right margin.
1 represents the right border of the image; 0 represents the left border. In Set mode, the slider
defaults to 1 (right border).
Top
Defines the top border of the DoD. Higher values on this slider move the top border toward the
bottom, excluding more data from the top margin.
1 represents the top border of the image; 0 represents the bottom border. In Set mode, the
slider defaults to 1 (top border).
Chapter – 100 Miscellaneous Nodes 2229