User Manual

Table Of Contents

Original 50-frame animation

In the below example, the duration of the clip is extended to 75 frames. The first 10 frames and

the last 10 frames of the animation run at the same speed as the original animation, while any

animation in the middle is stretched to fill the difference.

NOTE: The actual Spline Editor will show only the original keyframe positions. The

splines are not changed by the Keyframe Stretcher; only the animation is changed.

Animation modified to 75 frames but stretching only the middle of the animation

Inspector

Keyframes Tab

The Keyframes tab includes Source controls for setting the source duration and Stretch controls

for setting the area of the animation that gets modified.

Source Start/Source End

A source range is specified using the Source Start and Source End controls. These are typically

set to match the full range of the animation spline on the Keyframes control.

Chapter – 100 Miscellaneous Nodes 2224