User Manual

Table Of Contents
Basic Node Setup
The image connected to the orange input is frame averaged based on the settings in the
Inspector.
A Frame Average node blends the input image’s frames
Inspector
Controls Tab
The Controls tab contains the parameters for setting the duration and guidance of the
averaged frames.
Sample Direction
The Sample Direction menu determines if the averaged frames are taken before the current
frame, after, or a mix of the two.
Forward: Averages the number of frames set by the Frames slider after the
current frame.
Both: Averages the number of frames set by the Frames slider, taking frames before
and after the current frame.
Backward: Averages the number of frames set by the Frames slider before the
current frame.
Missing Frames
This control determines the behavior if a frame is missing from the clip.
Duplicate Original: Uses the last original frame until a new frame is available.
Blank Frame: Leaves missing frames blank.
Frames
This slider sets the number of frames that are averaged.
Chapter – 100 Miscellaneous Nodes 2222