User Manual

Table Of Contents
Basic Node Setup
The Custom Tool below takes two image inputs and a matte input, and then combines them
using some calculation. The result can be output to a Merge or other image-processing nodes.
A Custom Tool is used to build your own effects using C++ and scripting
Inspector
Controls Tab
Point in 1-4, X and Y
These four controls are 2D X and Y center controls that are available to expressions entered in
the Setup, Intermediate, and Channels tabs as variables p1x, p1y, ...., p4x, p4y. They are normal
positional controls and can be animated or connected to modifiers as any other node might.
Number in 1-8
The values of these controls are available to expressions entered in the Setup, Intermediate,
and Channels tabs as variables n1, n2, n3, ..., n8. They are normal slider controls and can be
animated or connected to modifiers exactly as any other node might.
Chapter – 100 Miscellaneous Nodes 2209