User Manual

Print to Console
Verbose output of the Timecode/Frame value in the Console.
The Timecode/Frames conversion is done according to the FPS settings. The result might look
like this:
TimeCode: 00:00:08:15
Frames: 207
Common Controls
Settings Tab
The Settings tab in the Inspector is also duplicated in other Metadata nodes. These common
controls are described in detail in the following “The Common Controls” section.
The Common Controls
Nodes that handle metadata operations share several identical controls in the Inspector. This
section describes controls that are common among Metadata nodes.
Inspector
Settings Tab
The Settings tab in the Inspector can be found on every tool in the Metadata category. The
controls are consistent and work the same way for each tool.
Use Object/Use Material (Checkboxes)
Some 3D software can render to file formats that support additional channels. Notably, the EXR
file format supports Object ID and material ID channels, which can be used as a mask for the
effect. These checkboxes determine whether the channels are used, if present. The specific
Material ID or Object ID affected is chosen using the next set of controls.
Chapter – 99 Metadata Nodes 2201