User Manual

Inputs
There are no inputs on the LUT Cube Creator. The purpose of the node is to generate an image
that can be used to create a LUT.
Basic Node Setup
The example below shows a node tree starting with a LUT Cube Creator node and going
through two color adjustments. The adjusted image is then connected into a LUT Cube
Analyzer that generates the LUT file.
Generating a LUT starts with the LUT Cube Creator and ends with a LUT Cube Analyzer
Inspector
Controls Tab
The Controls tab creates a test pattern of sorts used to create a 3D LUT. The controls here
determine the complexity of the pattern used to create a LUT using the LUT Cube Analyzer.
Type:
The Type menu is used to create a pattern of color cubes.
 Horizontal: Creates a long, horizontal strip representing a color cube.
 Vertical: Creates a long, vertical strip representing a color cube.
 Rect: Creates a rectangular image, as depicted below, representing a color cube.
A Cube image created with the Rect type The resulting color cube
Chapter – 96 LUT Nodes 2094