User Manual

LUT Cube Analyzer [LCA]
The LUTCubeAnalyzer node
LUT Cube Analyzer Node Introduction
The LUT Cube Analyzer takes an image originated by the LUT Cube Creator as an input and
allows the user to create a 3D LUT file in ALUT3, ITX, or 3DL format.
Feeding the original LUT Cube Creator image into the node results in an unaltered, or 1:1, LUT
file, and nothing is displayed in the viewer.
You can, however, modify, grade, and color correct the original cube image with as many nodes
as you like and feed the result into the LUT Cube Analyzer. This creates a LUT that exactly
resembles your color pipeline.
Inputs
The LUT Cube Analyzer includes a single orange input.
–
Input: The orange input is used to take the output of any node modifying an image
that originated with the LUT Cube Creator.
Basic Node Setup
The example below shows a node tree starting with a LUT Cube Creator node and going
through two color adjustments. The adjusted image is then connected to a LUT Cube Analyzer,
which generates the LUT file.
Generating a LUT starts with the LUT Cube Creator and ends with a LUT Cube Analyzer
Inspector
Chapter – 96 LUT Nodes 2091