User Manual

Common Controls
Settings Tab
The Settings tab controls are common to all Film nodes, so their descriptions can be found in
the following “The Common Controls” section.
The Common Controls
Film nodes share a number of identical controls in the Inspector. This section describes controls
that are common among Film nodes.
Inspector
Settings Tab
The Settings tab in the Inspector can be found on every tool in the Film category. The Settings
controls are even found on third-party Film-type plug-in tools. The controls are consistent and
work the same way for each tool, although some tools do include one or two individual options,
which are also covered here.
Blend
The Blend control is used to blend between the tool’s original image input and the tool’s final
modified output image. When the blend value is 0.0, the outgoing image is identical to the
incoming image. Commonly, this causes the tool to skip processing entirely, copying the input
straight to the output.
Chapter – 90 Film Nodes 2029