User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab contains all the primary controls necessary for customizing the rays.
Center X and Y
This coordinate control and related viewer crosshair set the center point for the light source.
Blend
Sets the percentage of the original image that’s blended with the light rays.
Decay
Sets the length of the light rays.
Weight
Sets the falloff of the light rays.
Exposure
Sets the intensity level of the light rays.
Threshold
Sets the luminance limit at which the light rays are produced.
Common Controls
Settings Tab
The Settings tab controls are common to all Effect nodes, so their descriptions can be found in
“The Common Controls section at the end of this chapter.
Chapter – 88 Effect Nodes 1958