User Manual

Table Of Contents
Radial Repeat
This control repeats the effect of the radial splines by x number of times. For example, a repeat
of 2.0 causes the spline to take effect between 0 and 180 degrees instead of 0 and 360,
repeating the spline between 180 and 360.
Length Angle
This control rotates the effect of the Radial Length spline around the circumference of
the hot spot.
Density Angle
This control rotates the effect of the Radial Density spline around the circumference of
the hot spot.
NOTE: Right-clicking in the spline area displays a contextual menu containing options
related to modifying spline curves.
A complete description of LUT Editor controls and options can be found in Chapter 45,
“LUT Nodes.
L1, L2, and L3 Tab
L1 tab L2 tab
Chapter – 88 Effect Nodes 1953