User Manual

Inspector
Controls Tab
The Controls tab for the OCIO File Transform node includes options to import the LUT, invert
the transform, and select the color interpolation method.
LUT File
Displays a File > Open dialog to load the desired LUT.
CCC ID
This is the ID key used to identify the specific file transform located within the ASC CDL color
correction XML file.
Direction
Toggles between Forward and Reverse. Forward applies the corrections specified in the node,
while Reverse tries to remove those corrections. Keep in mind that not every color correction
can be undone. Imagine that all slope values have been set to 0.0, resulting in a fully black
image. Reversing that operation is not possible, neither mathematically nor visually.
Interpolation
Allows the user to select the color interpolation to achieve the best quality/render time ratio.
Nearest is the fastest interpolation, while Best is the slowest.
Settings Tab
The Settings tab in the Inspector is also duplicated in other Color nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
Set Canvas Color [SCV]
The SetCanvasColor node
Set Canvas Color Node Introduction
Set Canvas Color is used to set the color of the area outside the domain of definition (DoD).
This is the workspace area beyond the raster by default, which is invisible since outside the
raster is not rendered. However, the DoD can be within the raster as well. This can occur when
Chapter – 85 Color Nodes 1895