User Manual

Table Of Contents
Basic Node Setup
The OCIO Color Space node is typically placed directly after a MediaIn node in DaVinci Resolve
or a Loader node in Fusion Studio. Another OCIO Color Space node is placed just before a
Media Out node in DaVinci Resolve or a Saver node in Fusion Studio.
An OCIO Color Space node applied to a Loader node and a Saver node in Fusion Studio
Inspector
Controls Tab
The Controls tab for the OCIO Color Space node allows you to convert an image from one color
space to another based on an OCIO config file. By default, it uses the config file included with
Fusion; however, the Controls tab does allow you to load your own config file as well.
OCIO Config
Displays a File > Open dialog to load the desired config file.
Source Space
Based on the config file, the available source color spaces are listed here.
The content of this list is based solely on the loaded profile and hence can vary immensely. If
no other OCIO config file is loaded, the DefaultConfig.ocio file in Fusion’s LUTs directory is
used to populate this menu.
Output Space
Based on the config file, the available output color spaces are listed here.
The content of this list is based solely on the loaded profile and hence can vary immensely. If
no other OCIO config file is loaded, the DefaultConfig.ocio file in Fusion’s LUTs directory is
used to populate this menu.
Look
Installed OCIO Color Transform Looks appear in this menu. If no looks are installed, this menu
has only None listed as an option.
Settings Tab
The Settings tab in the Inspector is also duplicated in other Color nodes. These common
controls are described in detail at the end of this chapter in “The Common Controls” section.
Chapter – 85 Color Nodes 1893