User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab for the Gradient node control the pattern and colors used for the
gradient texture.
Gradient Type
Determines the type or pattern used for the gradient.
Linear: A simple linear gradient.
Reflect: Based on the Linear mode, this gradient is mirrored at the middle of the
textured range.
Square: The gradient is applied using a square pattern.
Cross: Similar to the Reflect mode, but Cross uses two axes to apply the gradient.
Radial: The Radial mode uses a circular pattern to apply the gradient.
Gradient Bar
The Gradient control consists of a bar where it is possible to add, modify, and remove color
stops of the gradient. Each triangular color stop on the Gradient bar represents a color in the
gradient. It is possible to animate the color as well as the position of the point. Furthermore, a
From Image modifier can be applied to the gradient to evaluate it from an image.
Chapter – 83 3D Texture Nodes 1810