User Manual

Inspector
Controls Tab
The Controls tab is used to set the color and brightness of the directional light. The direction of
the light source is controlled by the rotation controls in the Transform tab.
Enabled
When the Enabled checkbox is turned on, the directional light affects the scene. When the
checkbox is turned off, the light is turned off. This checkbox performs the same function as the
red switch to the left of the node’s name in the Inspector.
Color
Use this standard Color control to set the color of the light.
Intensity
Use this slider to set the Intensity of the directional light. A value of 0.2 indicates 20%
percent light.
Common Controls
Transform and Settings Tabs
The options presented in the Transform and Settings tabs are commonly found in other lighting
nodes. For more detail on the controls found in these tabs, see “The Common Controls” section
at the end of this chapter.
Chapter – 81 3D Light Nodes 1755