User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab is used to set the color and brightness of the ambient light.
Enabled
When the Enabled checkbox is turned on, the ambient light affects the scene. When the
checkbox to turned off, the light is turned off. This checkbox performs the same function as the
red switch to the left of the node’s name in the Inspector.
Color
Use this standard Color control to set the color of the light.
Intensity
Use this slider to set the Intensity of the ambient light. A value of 0.2 indicates 20% percent
light. A perfectly white texture lit only with a 0.2 ambient light would render at 20% gray
(.2, .2, .2).
Common Controls
Transform and Settings Tabs
The options presented in the Transform and Settings tabs are commonly found in other lighting
nodes. For more detail on the controls found in these tabs, see “The Common Controls” section
at the end of this chapter.
Chapter – 81 3D Light Nodes 1753