User Manual

Table Of Contents
Inspector
Controls Tab
The Controls tab determines the number of ribbon strands, their size, length, and spacing.
Number of Lines
The number of parallel lines drawn between the start point and end point.
Line Thickness
Line thickness is allowed in the user interface to take on a floating-point value, but some
graphics cards allow only integer values. Some cards may only allow lines equal to or thicker
than one, or max out at a certain value.
Subdivision Level
The number of vertices on each line between start point and end points. The higher the
number, the more precise and smoother 3D displacement appears.
Ribbon Width
Determines how far the lines are apart from each other.
Start
XYZ control to set the start point of the ribbon.
End
XYZ control to set the end point of the ribbon.
Ribbon Rotation
Allows rotation of the ribbon around the virtual axis defined by start point and end points.
Chapter – 80 3D Nodes 1711