User Manual

Table Of Contents
Jitter Tab
The Jitter tab can be used to introduce randomness to various parameters.
Random Seed/Randomize
The Random Seed is used to generate the jitter applied to the replicated objects. Two Replicate
nodes with identical settings but different random seeds will produce two completely different
results. Click the Randomize button to assign a Random Seed value.
Time Offset
Use the Time Offset slider to offset any animations that are applied to the source geometry.
Unlike Time Offset on the Controls tab, Jitter Time Offset is random, based on the Random
Seed setting.
Translation XYZ Jitter
Use these three controls to adjust the variation in the translation of the replicated objects.
Rotation XYZ Jitter
Use these three controls to adjust the variation in the rotation of the replicated objects.
Pivot XYZ Jitter
Use these three controls to adjust the variation in the rotational pivot center of the replicated
objects. This affects only the additional jitter rotation, not the rotation produced by the rotation
settings in the Controls tab.
Scale XYZ Jitter
Use this control to adjust the variation in the scale of the replicated objects. Uncheck the Lock
XYZ checkbox to adjust the scale variation independently on all three axes.
Chapter – 80 3D Nodes 1709