User Manual

Table Of Contents
Inspector
Controls Tab
Enable
This checkbox enables the material replacement. This is not the same as the red switch in the
upper-left corner of the Inspector. The red switch disables the tool altogether and passes the
image on without any modification. The enable checkbox is limited to the effect part of the tool.
Other parts, like scripts in the Settings tab, still process as normal.
Replace Mode
The Replace Mode section offers four methods of replacing each RGBA channel:
Keep: Prevents the channel from being replaced by the input material.
Replace: Replaces the material for the corresponding color channel.
Blend: Blends the materials together.
Multiply: Multiplies the channels of both inputs.
Limit by Object ID/Material ID
When enabled, a slider appears where the desired IDs can be set. Other objects keep their
materials. If both options are enabled, an object must satisfy both conditions.
Common Controls
Material and Settings Tabs
The remaining controls for the Material and Settings tabs are common to many 3D nodes. Their
descriptions can be found in “The Common Controls” section at the end of this chapter.
Chapter – 80 3D Nodes 1701