User Manual

Inspector
Controls Tab
Enabled
When this checkbox is enabled, the projector affects the scene. Disable the checkbox to turn
off the projector. This is not the same as the red switch in the upper-left corner of the Inspector.
The red switch disables the tool altogether and passes the image on without any modification.
The Enabled checkbox is limited to the effect part of the tool. Other parts, like scripts in the
Settings tab still process as normal.
Color
The input image is multiplied by this color before being projected into the scene.
Intensity
Use this slider to set the Intensity of the projection when the Light and Ambient Light projection
modes are used. In Texture mode, this option scales the Color values of the texture after
multiplication by the color.
Decay Type
A projector defaults to No Falloff, meaning that its light has equal intensity on geometry, despite
the distance from the projector to the geometry. To cause the intensity to fall off with distance,
set the Decay type to either Linear or Quadratic modes.
Angle
The Cone Angle of the node refers to the width of the cone where the projector emits its full
intensity. The larger the angle, the wider the cone angle, up to a limit of 90 degrees.
Chapter – 80 3D Nodes 1687