User Manual

Pivot Jitter
Use these three controls to adjust the amount of variation in the rotational pivot center of the
duplicated objects. This affects only the additional jitter rotation, not the rotation produced by
the Rotation settings in the Controls tab.
Scale Jitter
Use this control to adjust the amount of variation in the scale of the duplicated objects. Disable
the Lock XYZ checkbox to adjust the scale variation independently on all three axes.
Region Tab
The options in the Region tab allow you to define an area in the viewer where the copies can
appear or are prevented from appearing. Like most parameters in Fusion, this area can be
animated to cause the copied object to pop on and off the screen based on the region’s shape
and setting.
Duplicate 3D Region tab
Region Tab
The Region section includes two settings for controlling the shape of the region and the affect
the region has on the duplicate objects.
 Region Mode: There are three options in the Region Mode menu. The default, labeled
“Ignore region” bypasses the node entirely and causes no change to the copies of
objects from how they are set in the Controls and Jitter tabs. The menu option labeled
“When inside region” causes the copied objects to appear only when their position falls
inside the region defined in this tab. The last menu option, “When not Inside region”
causes the copied objects to appear only when their position falls outside the region
defined in this tab.
Chapter – 80 3D Nodes 1663