User Manual

Table Of Contents
Transform Method
Linear: When set to Linear, transforms are multiplied by the number of the copy, and the
total scale, rotation, and translation are applied in turn, independent of the other copies.
Accumulated: When set to Accumulated, each object copy starts at the position of the
previous object and is transformed from there. The result is transformed again for the
next copy
Transform Order
With this menu, the order in which the transforms are calculated can be set. It defaults to
Scale-Rotation-Transform (SRT).
Using different orders results in different positions of your final objects.
Translation
The X, Y, and Z Offset sliders set the offset position applied to each copy. An X offset of 1 would
offset each copy 1 unit along the X-axis from the last copy.
Rotation
The buttons along the top of this group of rotation controls set the order in which rotations are
applied to the geometry. Setting the rotation order to XYZ would apply the rotation on the
X-axis first, followed by the Y-axis rotation, then the Z-axis rotation.
The three Rotation sliders set the amount of rotation applied to each copy.
Pivot
The pivot controls determine the position of the pivot point used when rotating each copy.
Scale
Lock: When the Lock XYZ checkbox is selected, any adjustment to the duplicate scale
is applied to all three axes simultaneously. If this checkbox is disabled, the Scale slider
is replaced with individual sliders for the X, Y, and Z scales.
Scale: The Scale controls tell Duplicate how much scaling to apply to each copy.
Chapter – 80 3D Nodes 1661