User Manual

Table Of Contents
5 Click the Overlay checkbox to see the current frame and the offset frame
superimposed.
6 Drag the Time Offset slider to select the source frame you want to use.
7 Option-click over the area in the viewer you want to use as the source or to offset the
source frame’s position.
Overlay shows two frames overlapped with Time Offset,
allowing you to clone from one frame onto another.
8 Paint over the area you want to cover up using the source pixels.
The plane is half painted out using on the Overlay with Time Offset.
9 Disable the Overlay checkbox.
The Clone Apply Mode can use a different
frame from the same clip.
TIP: When using a Clone Apply Mode, you can hold down the O key instead of clicking
the Overlay checkbox in Inspector to see the Overlay. Releasing the O key will return
to normal viewing without the Overlay.
Chapter – 72 Paint 1466