User Manual

Table Of Contents
The Source menu is used to choose the color profile for your Loader or MediaIn node. The
default raw setting shows an unaltered image, essentially applying no color management to the
clip. The selection you make from the menu is based on the recording profile of your media.
The Output menu is set based on your deliverables. When working in Fusion Studio, typically
the Output selected is ACEScg, to work in a scene linear space.
Applying OCIO LUTs in the Viewer
The viewer also includes OCIO View LUTs to calibrate the viewers. Once the OCIO Color Space
View LUT is selected from the LUT menu above the viewer, choosing Edit for the same menu
opens a dialog where you can load the OCIO config file.
The OCIO Color Space View LUT is located in the
Viewer LUT menu in Fusion Studio.
By default, the same standard options are available in the View LUT. However, clicking the
Browse button allows you to load the same config file you loaded into the OCIO Color Space
node. Once loaded, all the expanded OCIO options are available. If you selected the OCIO
Color Space node to output ACEScg, you use the OCIO View LUT to go from a source setting of
linear sRGB to an output setting of sRGB or Rec 709 in most cases.
The OCIO Color Space View LUT dialog is
used to configure the viewer when using the
OCIO Color Space node in the Node Editor.
TIP: If your monitor is calibrated differently, you will need to select a LUT that matches
your calibration.
Chapter – 68 Managing Color for Visual Effects 1379