User Manual

4 Set the Type to Point.
5 Select Controls in the Page list. (Controls is the first tab in the Inspector, normally.)
6 Click OK.
DirectionalBlur Center parameter name changed to Blur Vector.
The new Blur Vector parameter now appears in the Inspector. The internal ID of the control is
still Center, so our SimpleExpressions did not change.
To hide the Length and Angle parameters in the Inspector:
1 In the Edit Control dialog, select the Length from the ID list.
2 Select Controls from the Page list.
3 In the input Ctrl list, select Node.
4 Click OK.
5 In the Edit Control dialog, select the Angle from the ID list.
6 In the input Ctrl list, select Node.
7 Click OK.
Finally, to remove Radial and Zoom options from the Type menu:
1 In the Edit Control dialog, select the Type from the ID list.
2 Select Controls from the Page list.
3 Select Radial from the Items list and click Del to remove it.
4 Select Zoom from the Items list and click Del to remove it.
5 Click OK.
The Type menu now includes only two options.
If you want to replace the Type menu with a new checkbox control, you can do that by creating
a new control and a very short expression.
Chapter – 63 Using Modifiers, Expressions, and Custom Controls 1273