User Manual

To disable a filter and show all tools in the Spline Editor again:
 Choose Show All from the Options menu.
Changing a Spline’s Status
The Spline header is a hierarchical list of animated parameters and their parent nodes. Clicking
the disclosure arrow next to a tool’s name reveals all the names of the animated parameters on
that tool. Clicking directly on the parameter name in the Spline header activates that spline for
display and editing.
The Spline header with the Brightness
Contrast tool and its animated Gain
and Gamma parameters.
Tool Status Checkbox
Next to the name of each spline is a checkbox that indicates the spline’s status. When you
select a parameter name, the checkbox becomes active, allowing you to see and edit the spline
in the graph. There are three selection modes for each checkbox: active, viewed, and disabled.
Clicking directly on the checkbox will toggle it between these three states. Changing the state
of the parent node checkbox sets the state for all splines for that node.
 Active: When the checkbox is enabled with a check mark, the spline is displayed in the
graph and can be edited.
 Viewed: When the checkbox is enabled with a solid gray box, the spline is visible in the
graph but cannot be edited. It is read-only.
 Disabled: When the checkbox is clear, the spline is not visible in the graph and cannot
be edited.
Checkboxes determine which splines
are visible and editable.
Chapter – 61 Animating in Fusion’s Spline Editor 1233