User Manual

Removing Animation From a Parameter
To remove all keyframes from a parameter:
1 Right-click over the name of the keyframed parameter in the Inspector.
2 Choose Remove “node name:parameter name” from the contextual menu.
TIP: If you change the default spline type from Bézier, the contextual menu will display
the name of the current spline type.
Attaching a Parameter to an Existing Animation Curve
Multiple parameters can be connected to the same animation curve. This can be an invaluable
timesaver if you are identically animating different parameters in a node.
To connect a second parameter to the same animation curve:
1 Right-click on the second parameter you want to attach.
2 In the contextual menu, hover over the Connect To submenu.
3 In the Connect To submenu, choose the name of the animated parameter.
Connecting Parameters
It is often useful to connect two parameters together even without an animation curve. There
are two methods you can use.
Connecting Parameters by Publishing
If you want to tie two parameters together so adjusting one adjusts the other, you must connect
them together using the Publish menu command on the first parameter and the Connect menu
command on the second parameter.
To Publish and Connect parameters:
1 Right-click the name of the parameter you want to publish, and choose Publish from the
contextual menu.
2 Right-click on the second parameter you want to attach, and choose the name of the
parameter you just published from the Connect To submenu.
The Publish contextual menu.
Chapter – 59 Editing Parameters in the Inspector 1189