User Manual

Table Of Contents
The Eyedropper with color swatch.
The Color Picker normally selects from a single pixel in the image, but you can adjust the size of
the selection by dragging into the viewer with the Eyedropper, and then holding Command and
dragging out a rectangle for the sample size you want. The size change applies to all Color
Pickers until the size is changed again.
Gradients
The Gradient Control bar is used to create a gradual blend between colors. The Gradient bar
displays a preview of the colors used from start to end. By default, there are two triangular color
stops: one on the left that determines the start color, and one on the right that determines the
end color.
The default Gradient controls.
Gradient Type
The Gradient Type button array is used to select the form used to draw the gradient. Linear
draws the gradient along a straight line from the starting color stop to the ending color stop.
Linear gradient.
Reflect draws the gradient by mirroring the linear gradient on either side of the starting point.
Reflect gradient.
Chapter – 59 Editing Parameters in the Inspector 1185