User Manual

The viewer divider bar.
Zooming and Panning into Viewers
There are standardized methods of zooming into and panning around viewers when you need a
closer look at the situation. These methods also work with the Node Editor, Spline Editor, and
Keyframes Editor.
Methods of panning viewers:
 Middle-click and drag to pan around the viewer.
 Hold down Shift and Command and drag the viewer to pan.
 Drag two fingers on a track pad to pan.
Methods of scaling viewers:
 Click a viewer and press the Equals key (=) to zoom in, and the Minus key (-)
to zoom out.
 Press the middle and left mouse buttons simultaneously and drag left or right to resize
the viewer.
 Hold down the Command key and use your pointer’s scroll control to resize the viewer.
 Hold down the Command key and drag two fingers on a track pad to resize the viewer.
 Hold down the middle mouse button, and then click the left mouse button to zoom in,
or click the right button to zoom out. The scaling uses a fixed amount, centered on the
position of the cursor.
 Click a viewer and press Command-1 to resize the image in the viewer to 100 percent.
 Click a viewer and press Command-F or Command-1 to reset the image in the viewer to
fit the viewer.
Chapter – 58 Using Viewers 1133