User Manual
Table Of Contents
- Getting Started
- Using Web Presenter HD’s Front Panel
- Using the Monitor Output
- Using Web Presenter Setup
- Network Settings
- Setting Internet Sharing for Direct Streaming
- Streaming Using Your Smartphone
- Using Blackmagic Web Presenter HD as a Webcam
- Creating Video Links with ATEM Streaming Bridge
- Teranex Mini Rack Shelf
- Updating the Internal Software
- Developer Information
- Help
- Regulatory Notices
- Safety Information
- Warranty
Connecting a Monitor
Plug your HDMI television or SDI monitor into one of the monitor outputs. This lets you monitor
your broadcast and observe important status information that updates constantly with your
video stream. For more information on how to use the monitor output, refer to the ‘Using the
Monitor Output’ section.
Connect a monitor to your web presenter’s monitor output
Connecting to a Computer via USB
Connect your Web Presenter HD to your computer using the USB-C port on the front or rear
panel. These USB ports are used for updating the unit and configuring it with the Blackmagic
Web Presenter Setup utility. Once you have configured your Web Presenter for the first time,
you can then disconnect the unit from the computer.
Connect your Blackmagic Web Presenter HD to your
computer using the USB port on the front or rear panel
Connecting to the Internet
Connect your Blackmagic Web Presenter HD to the internet by plugging a network cable from
the ‘live stream’ Ethernet port to an internet router or a network switch.
Connect your Blackmagic Web Presenter HD to your
network via the Ethernet port on the rear panel
5Getting Started