Instruction Sheet

ASSEMBLY & INSTALLATION INSTRUCTIONS for: BNC-27V-SN
CAUTION: READ ALL INSTRUCTIONS CAREFULLY FOR SAFE OPERATION AND INSTALLATION.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture in order to prevent possible
shock.
GENERAL
1. All electrical connections must be in accordance with local and national electrical code (N.E.C)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician. Remove the fixture and the mounting hardware from the box. Make sure that
no parts are missing by referencing the illustrations below.
2. Dimming controller type: TRIAC phase control dimmer.
3. Recommended TRIAC dimmers:
LUTRON: ARIADNI AYCL-153P, DIVA DVCL-153P, SKYLARK CTCL-153P, SKYLARK SCL-153P;
LEVITON: ILLUMATECH IPI06-1L, ILLUMATECH IPI10-1L, DECORA DSL06, DECORA DSM10;
LEGRAND: ADORNE: WHISPER/ ADWR, SOFTTAP/ ADTP, TOUCH/ ADTH.
ASSEMBLY AND INSTALLATION
1. Take the fixture out of the box.
2. Remove the fixture pan （9）from the back panel（10）by loosening two screws（12).
3. Pull the supply wires (2&3) and the house ground wire (4) out of the outlet box (1). Temporarily
attach back panel (10) to the outlet box (1) by carefully positioning the rear mounted driver into the
junction box, taking care to push aside the supply and ground wires that might interfere. Use the
two inner mounting screws (11) to temporarily support the fixture against the wall. Mark the two
outer mounting hole locations (for anchor screw 13) on either side of the back canopy.
4. Remove the back panel (10) from the wall. Drill the two holes using the appropriately sized drill bit.
Insert the provided ceiling anchors (14) into the holes.
5. Connect the wires: connect the white supply wire (2) to the white fixture wire (7); connect the black
supply wire (3) to the black fixture wire (6); connect the house ground wire (4) to the fixture ground
wire (8) using wire connectors (5).
6. Carefully re-insert the driver into the junction box. Screw the outer anchor screws (13) halfway into
the ceiling anchors, then further attach back panel (10) to the outlet box (1) by using two inner
mounting screws (11). Afterward fully tighten outer anchor screws (13).
7. Secure the fixture pan (9) to the back panel (10) by attaching the two screws (12).