Instruction Manual

2.3 Level 2 SERPA

Auto Lock

™

Test

After properly adjusting the level 1 passive retention, test the SERPA

Auto Lock

™

several times for proper

functioning. Confirm the following:

1. When holstering, the SERPA

Auto Lock

™

shouldengagethetriggerguardwithanaudible“click.”

2. When seated inside the holster, the firearm should not rattle or move excessively.

3. When your firearm is properly seated in the holster and constant upward force is applied to the firearm, you

should not be able to activate the SERPA

fingertray.(Thisisanintendedfeaturedesignedtoimmobilize

yourweaponifsomeoneisattemptingtodisarmyou.)

4. When the SERPA

finger tray is pressed, the SERPA Auto Lock

™

should not interfere with any part of the

firearm as it is removed from the holster.

2.4 Level 3 Pivot Guard Test (for Level 3 Duty and Light Bearing Holsters only)

1. With your firearm properly seated in the holster, press and hold the Pivot Guard thumb release with your

firing hand thumb.

2. While holding the Pivot Guard thumb release down, roll your index and middle fingers over the top of the

Pivot Guard and pull it to the rear over the slide of the firearm.