Instruction Manual

2.InsertanUNLOADEDfirearmintotheholsteruntiltheSERPA
®
Auto Lock
™
engagesonthefirearm’strigger
guard.ForLightBearingHolsters,makesuretheXiphoslightisinstalledproperlyonyourfirearmbefore
holstering.Makesurethatnopartoftheholsterinterfereswiththetrigger,safetyfeatures,sights,
magazinerelease,compatibleaccessoriesoranyotherpartofthefirearm.
WARNING!: If your holster interferes with any of these parts of the firearm, DO NOT USE. Interferences
cancauseanunintendeddischargeand/orinterferewithretentionmechanisms.Donotattempttomodify
or alter any portion of the holster in any way or add any lubricants or chemicals to make your firearm fit.
Contact BLACKHAWK!
®
for a replacement.
3. Depress the SERPA
®
fingertraywithindexfingerflattened/straightandpullonthefirearm.Thereshouldbe
little or no resistance at this point when attempting to remove the firearm. If your firearm does not come out
of the holster easily, contact BLACKHAWK!
®
for a replacement.
4.Turningthepassiveretentionscrewclockwisein1/8turnincrements,testthepassiveretentionbypulling
uponyourfirearm(withtheSERPA
®
fingertraydepressed)untilthedesiredlevelofpassiveretentionis
achieved. The passive retention screw should be just tight enough so that the firearm does not fall out of
the holster when turned upside down with the SERPA finger tray depressed.
NOTE: Tightening the passive retention screw too much can inhibit your draw or wear the finish off the
trigger guard on your firearm.
11