User manual

INSTALLING THE COMPUTER ON YOUR BIKE INSTALLING THE COMPUTER ON YOUR BIKE

ENGLISH

INSTALLING WIRED REAR WHEEL SPEED AND CADENCE

SENSORS AND BRACKET

(CONTINUED)

7. Route the sensor wire forward and under the bottom bracket and along the bottom of the

down tube securing it occasionally with tape. Once you are near the head tube the sensor

wire should be wrapped around the front or rear derailleur cable housing and the around

the front brake cable housing.

CAUTION—Make sure you leave enough slack in the sensor wire so the handle bars can turn fully

from side to side without creating any stress.

8. Attach the bracket to the handlebars and tighten the mounting screw.

ATTACHING THE COMPUTER HEAD TO THE

HANDLEBAR BRACKET AND TESTING

When the bracket and sensors are completely installed on the bike, slide the

Delphi computer unit into the handlebar bracket. The computer should LOCK

into the bracket with an AUDIBLE "CLICK". If you do not hear a click or if

the Delphi computer body is not flush with the back edge of the bracket the

computer is not locked in place and may come out.

Once everything is assembled spin the wheel and turn the crank and make

sure speed and cadence are being displayed on the screen. If you are not

receiving one or both pieces of information, check the magnet and sensor

alignment and make sure the magnets are passing the proper point on the

sensor and that they are within 1-3mm. If they are closer to 3mm than to

1mm try reducing the gap and test the system again.

CYCLE COMPUTER

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 16