User manual

INSTALLING THE COMPUTER ON YOUR BIKE INSTALLING THE COMPUTER ON YOUR BIKE

ENGLISH

INSTALLING WIRED REAR WHEEL SPEED AND CADENCE

SENSORS AND BRACKET

(CONTINUED)

3. Adjust and position the sensor as closely as possible to the magnet and rotate the sensor

so the magnet passes within 1-3mm. Fully tighten the zip-ties once you have everything

properly aligned.

4. Depending on the length of your chainstays and where you want to position the sensor,

wrap the speed sensor wire once or twice around the chainstay and attach the speed

sensor using the zip-ties provided.

5. Attach the spoke magnet to a spoke on the same side of the wheel as the sensor. Tighten

the attachment screw just enough to hold the magnet in place but loose enough so that it

is still movable.

6. Adjust the position of the sensor and magnet so they are in proper alignment as shown in

the drawing tighten the zip-ties and magnet.

CYCLE COMPUTER

INSTALLING WIRED REAR WHEEL SPEED AND CADENCE

SENSORS AND BRACKET

On the Delphi 3.0, both speed and cadence are picked up from the rear wheel using a special

bracket, which has two sensors at the end of a long wire. One sensor picks up speed and

distance information from the rear wheel and the other picks up cadence information from the

crank. The cadence sensor is marked with a C.

1. Attach the cadence sensor to the LEFT chain stay near where the crank/pedal pass the

stay using the zip-ties provided. Snug up the zip-ties but do not fully tighten them. It is

recommended the cadence and rear wheel sensors be mounted on the top of the stay.

NOTE: The wires exiting the sensors should be pointing toward the front of the bike.

2. Attach the cadence magnet to the back side of the LEFT crank arm using the zip-tie

provided. The cadence magnet should be attached as closely to the pedal spindle as

possible.

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 14