User manual

INSTALLING THE COMPUTER ON YOUR BIKE INSTALLING THE COMPUTER ON YOUR BIKE

ENGLISH

The Delphi 2.0 uses a single wired sensor attached to the front fork.

1. Attach the front wheel sensor to either fork blade using the zip-ties

provided. Snug up the zip-ties but do not fully tighten them.

2. Attach the spoke magnet to a spoke on the same side of the wheel as

the sensor. Tighten the attachment screw just enough to hold the

magnet in place but loose enough so that it is still movable.

3. Adjust the position of the sensor and magnet so they are in proper

alignment as shown in the drawing and tighten the zip-ties and

magnet.

NOTE: The magnet should pass 1-3mm away from the sensor. The closer you

can get the magnet to the sensor the better.

INSTALLING WIRED FRONT WHEEL SPEED SENSOR AND BRACKET

(CONTINUED)

4. Route the remaining wire and bracket up the fork securing it with tape. Excess wire

should be wrapped around the brake cable housing until there is just enough slack

remaining to allow the bracket to be attached to the handlebars. Attach the bracket to

the handlebars and tighten the mounting screw.

NOTE: There are two molded plastic shims supplied with the Delphi computer brackets. The

THIN shim allows the bracket to fit Oversized 31.8 mm handlebars. The THICK shim

allows the bracket to fit standard 26.0mm handlebars.

CAUTION—When installing the system on a bicycle with front suspension, be sure to leave enough

slack for the action of the fork.

CYCLE COMPUTER

INSTALLING WIRED FRONT WHEEL SPEED SENSOR AND BRACKET

Blackburn_2/3_Manual 8/3/05 10:00 AM Page 12